ELM Video Technology, Inc.

DMX 0~10 Volt Converter / Switch / Relay Driver Module

Module DX10V2: is a DMX to 0~10 volt converter with up to 16 channels (20mA each), and can be used to convert existing dimmers to DMX or control relays such as solid state (SSRs) to trigger water fountain control solenoids for example. Other functions could be to directly drive LEDs to view DMX channel brightness or just monitor/verify DMX and channel activity. levels or control trigger  drive inputs . Available in a 4, 8, 12, or 16 channel module, each output is assigned a consecutive DMX channel and will vary from 0 to 10V in respect to the corresponding DMX channels' level OR if configured in the Switch mode the outputs will be either fully ON or OFF, useful for controlling solid state relays (SSR).  The Start Channel is assigned by dip switches 1 ~ 9, DMX512 CHANNEL ASSIGNMENT TABLE [PDF]. For example if the DMX start channel is assigned to 10, and the level on channel 10 is 127, then the 1st output will be +5 volts, level of 0 = 0 volts, and a level of 255 = 10 volts etc.). Each output will source 20mA. The variable output can drive 10V dimmers (insure your dimmers operate within these specifications, overdriving may cause failure).